what have you done to your bike today??

[Tramp]

Been a busy beaver....

stripped swing arm off the xt660z and regreased everything and copperslipped the shafts , fitted new chain and sprockets too just waiting on a new 525 soft link as my new chain was endless and yes i didnt look before putting swing arm back in lol.

so out with grinder and chain tool 5 mins later cut in half lol, last weekend I fitted new steering headstock bearings and a grease nipple plus some shorty brake,clutch lever...dont you love winter in the warm man cave getting greasy .

and ive fallen in love with my new tool ..impact wrench from maplins 450nm torque makes light work of stubborn nuts..

[diggermanbob]

Haven't done anything to it , but took the Fjr 1300 for a spin up the road holy shamoly it does motor

[Kirky1298]

Fitted some Barkbusters, fitted my new Xpannier rails from Outback Motortek. Tore down the front end ready to run wiring loom for spotlights. Found some rust under the tank. 9 weeks old and rusty, not a good sign. Tore off the tyres to convert the rims to tubeless. I just hope I can remember how to reassemble the front end. Lol.
If only I remembered how to add pictures

[UKJeeper]

Fitted some Barkbusters, fitted my new Xpannier rails from Outback Motortek. Tore down the front end ready to run wiring loom for spotlights. Found some rust under the tank. 9 weeks old and rusty, not a good sign. Tore off the tyres to convert the rims to tubeless. I just hope I can remember how to reassemble the front end. Lol.
If only I remembered how to add pictures.











Ok , sorry pics are not in order, I'll figure it out eventually. Lol.

None of the images are showing.

[Kirky1298]

Hopefully images are showing now.

[Trev]

Another go a getting the timing right on my ancient funduroped, fixed stator so you have to pivot the points half a gnats cock through a tiny flywheel window. Wish I had left the pitted to buggery ones in now

[willywombat64]

Kirky ..may I ask what you used to seal the spoke holes on the AT ?

[FatFreddy]

I finally got around to fitting my new Jesse luggage on my F650gs. It wasn’t easy as it seems the Akropovic slip on its fitted with must be bigger than the OE silencer. Made it a very tight fit. I’d post pics if I’d taken any yet.

[dual]

Took the old sprockets and chain and made something to use them a bit longer
Created a lamp out of them

[Fried Egg Sandwich]

Fitted the new Christmas bling.
A long overdue new gear change lever, to complement the new stator and new regulator/rectifier unit

IMG_20181225_154045861_HDR.jpg (85.57 KiB) Viewed 3501 times