That's what I did (thumbs)one-two-three-four wrote:flip the throttle assembly over so the cables exit on the underside should give a little more slack as well.
DRZ400S - highest bars without having to change cables etc?
-
special one
- Posts: 3055
- Joined: Mon Oct 10, 2011 4:36 pm
- Has thanked: 3 times
- Been thanked: 1 time
Re: DRZ400S - highest bars without having to change cables etc?
Current bikes...
2003 KTM 950 adventure in silvery blue...
2013 KTM 450 exc-f in orange /white
2007 Scorpa SY250 trials in blue.
2003 KTM 950 adventure in silvery blue...
2013 KTM 450 exc-f in orange /white
2007 Scorpa SY250 trials in blue.
-
Scott_rider
- Posts: 2436
- Joined: Wed Mar 21, 2012 12:47 pm
- Has thanked: 29 times
- Been thanked: 294 times
Re: DRZ400S - highest bars without having to change cables etc?
I had 'Renthal Dakar High' bars on my old one
Suzuki GSX-S1000F...the KTM 450 EXC-R has gone
-
daveuprite
- Posts: 4790
- Joined: Fri Dec 28, 2012 10:47 pm
- Location: Limousin France
- Has thanked: 2452 times
- Been thanked: 3293 times
Re: DRZ400S - highest bars without having to change cables etc?
Good tip, that. It works.one-two-three-four wrote:flip the throttle assembly over so the cables exit on the underside should give a little more slack as well.
Re: DRZ400S - highest bars without having to change cables etc?
I am a bit slow in replying but for what it's worth I used a set of Renthal Enduro High bars and 1 inch risers without any problem. I chose these bars for both height and width, at 830mm you won't find much wider and it certainly helps with control. The throttle cables can be re-routed from carb to the left side of the frame over to the right but I found it wasn't necessary ??? All the switch cables were fine on my 400S
- DSC_0416.JPG (38.68 KiB) Viewed 660 times
